Skip to content

Managing Services#

Once you have successfully installed the Privacera services, the PM UI allows you to manage the services from its Dashboard.

Installing Services#

You can install a service in an existing environment, where you have already installed and deployed Privacera services. To install a new service, perform the following steps:

  1. On the left navigation of the PM UI Dashboard, click System Settings. The Setup Environment page is displayed.

  2. Do the following:

  3. To start the install, go to Install and click Install & Start Services. To learn more on the installation, click here.

Updating Services#

When you update the configuration of a Privacera service by adding/editing a property, you need to run the installation for the changes to take effect. To update a service, perform the following steps:

  1. On the left navigation of the PM UI Dashboard, click on a service. The service configuration page is displayed.

  2. Do the following:

    • Click Config tab, and edit the existing properties.

    • Click Custom tab, and add a new property.

  3. To start the install, go to System Settings > Install and click Install & Start Services. To learn more on the installation, click here.

Starting and Stopping Services#

Once you have successfully installed the Privacera services, you can start/stop each service or from the Dashboard.

To start/stop a Privacera service, perform the following steps:

  1. On the left navigation of the PM UI Dashboard, click on a service. The service configuration page is displayed.

  2. Do the following:

    • To start the service, click Start Service.

    • To stop the service, click Stop Service.

Restarting Services#

When the status of a service(s) is displayed in red colour, you can restart the service or restart all the services. To do so, perform the following steps:

  1. On the left navigation of the PM UI Dashboard, click on a service. The service configuration page is displayed.

  2. Do the following:

    • To restart the service, click Restart Service.

    • To restart all the services, click Restart All Service at the top of the configuration page.

Updating Services vs. Restarting Services#

The following table tries to capture in which conditions you need to update or restart a service.

You want to do the following: Updating Services Restarting Services
Enable Troubleshooting of a service No Yes
Re-configure a service Yes No
Service is in a bad state and its status shows in red colour. No Yes